Table of Contents
Advertisement
Using the TX-CTB
Computer
To control the CD-I mouse, use the buttons labeled in yellow. Then, press one of the eight outer
number buttons (1 – 4 or 6 – 9). For information on the Speed and how to activate functions refer to
the CD-I Player subsection.
Slides
To control video slide projectors and still video players, use the following buttons::
Barcode Reader
To read a barcode:
1. Press READ. The LED turns green.
2. Hold the TX-CTB so the reader is perpendicular to the barcode.
3. Swipe the reader over the barcode until the TX-CTB beeps once. Follow these guidelines:
!
!
4. After the TX-CTB beeps once, point it at the AXB-TM5.
5. Press SEND. The LED turns yellow when the TX-CTB transmits the data.
After five seconds of inactivity, the TX-CTB beeps twice and returns to normal IR operation.
6
PLAY (slides on)
STOP (slides off)
PAUSE (still video standby)
FFWD (zoom in)
REV (zoom out)
FWD (forward)
REV (reverse)
If it does not beep, do not lift the reader from the page; swipe the reader over the barcode
in the other direction.
It may take more than one pass, or it may take a pass in theother direction to read the
barcode.
TX-CTB Classroom Transmitter and Barcode Reader
Advertisement
Table of Contents
