Battery ChargNg; Telephone Base Layout - VTech CS6114 Complete User's Manual

Getting started
Battery charging
Once you have nstalled the battery, the screen ndcates the battery
status (see the table below). If necessary, place the handset n the
telephone base or charger to charge the battery. For best performance,
keep the handset n the telephone base or charger when not n use. The
battery s fully charged after 16 hours of contnuous chargng. See the table
on page 27 for battery operatng tmes.
If the screen s blank, you need to charge the handset wthout nterrupton
for at least 30 mnutes to gve the handset enough charge to use the
telephone for a short tme. When the battery s low, the handset dsplays
Low battery along with a flashing
mode, the handset beeps every 50 seconds.
The followng table summarzes the battery charge ndcators and actons
to take.
Battery ndcators
The screen s blank,
or dsplays Place in
charger and
The screen dsplays
Low battery and
flashes.
The screen dsplays
HANDSET X and
--:-- --/--.
If you place the handset n the telephone base or charger wthout pluggng
n the battery, the screen dsplays No battery.

Telephone base layout

Battery status
Battery has very lttle or
no charge. The handset
flashes. cannot be used.
Battery has enough
charge to be used for a
short tme.
Battery s charged.
con. If you are on a call n low battery
Acton
Charge wthout nterrupton
(at least 30 mnutes).
Charge wthout nterrupton
(about 30 mnutes).
To keep the battery charged,
place t n the telephone
base or charger when not
n use.
IN USE lght
On when the handset s n use.
Flashes quckly when there s an
ncomng call.
Flashes when another telephone
sharng the same lne s n use.
/FIND HANDSET
Press once and then release to page
all system handsets (page 14).
5