GE CustomStyle Profile Performance 22 Owner's Manual page 23

Remove the Freezer Door
Tape the door shut with masking tape.
1
With a 1/4" socket and ratchet, remove the hinge cover on top
2
of the freezer door.
With a T20 Torx Driver, remove the two Torx screws that hold
3
the top hinge to the cabinet.
Lift the hinge straight up to free the hinge pin from the socket in
4
the top of the door.
Remove the tape and tilt the door away from the cabinet. Lift it
5
off the bottom socket.
Set the door on a non-scratching surface with the outside up.
6
Using a knife or putty knife with the end wrapped in masking tape,
7
pry out the four plug buttons from the left top of the cabinet, and
push them into the corresponding holes on the right side.
Remove the Fresh Food Door
Tape the door shut with masking tape.
1
Remove the middle hinge pin with a 7/16" socket and ratchet.
2
Remove tape and tilt the door away from the cabinet.
3
Lift the door straight up to free its bottom socket from the pin in the bottom hinge bracket.
4
Set the door on a non-scratching surface with the outside up.
5
Reversing the hardware.
Transfer the Bottom Hinge Bracket and the Stability Leg
Remove the base grille by pulling it straight out.
1
Using a T20 Torx Driver, remove the bottom hinge bracket.
2
With a 7/16" ratchet, remove the bottom hinge pin, along with the washer, and replace it on the
3
other side.
Again, using a T20 Torx Driver, remove the stability leg from the left side and reinstall it on the
4
right side.
Install the bottom hinge bracket on the left side.
5
(right side shown)
Washer
Stability Leg
23