Table of Contents
Advertisement
• Connecting an Ai-NET compatible AV head unit
I
Digital Audio Processor
Change the system switch on the AV
head unit to "EQ/DIV."
~
Ai-NET Input
Ai-NET Cable
Connector
'--':"::"':":::":""::':::"::""_Effi}:l
~
Ai-NET Cable (included)
Digital Audio Processor
PXA-H701 , etc.
(Sold Separately)
l P - - - - I ...
~
I
I
<l ...
I----EII
p 1--
--1
Ai-NET Input
Connector
(CHANGER IN)
Digital Input
Terminal (Optical)
(Changer)
m
I
Ai-NET Connector
Fiber Optic Cable
(Sold Separately)
Ai-NET Connector
...
Remote Control
Output Lead
~
(White/Brown)
R , _ """"""
0 ....
""""'f
Input Lead
Terminal
.)
(WhIle/Brown)
(Optical)
AV Head Unit
IVA-D106, etc. (Sold Separately)
AUXVideo
~
Input Terminal
I
RCA EXlension
Cable (included)
i
Video Output
CJJ=. -
Connector
.....
DHA-S690
Setting of DHA·S690
The DHA-S690's system settings must be
made after connections are completed.
Before fixing the unit in place, refer to
page 41 to change the system setting.
System Switch
1
2
[C]
Switches to "1".
• Be sure to switch the head unit's system switch before turning the power on.
• Be sure to make the setting (DVD CHG or CD CHG) in "Setting the Connected Head Unit" (page
21)
according to the connected Ai-NET
compatible head unit.
• If CD CHG is set in "Setting the Connected Head Unit" (page 21):
Ifyou want to ploy back a DVD Audio, set "Switching the input (non Ai-NET connections)" on the connected Alpine audio processor
(PXA-H700, PXA-H701) to "Analog." For details on operation, refer to the Owner's Manual ofthe audio processor.
• The switched Power Lead (Ignition) connection is not needed.
• Also refer to the operating instructions ofthe other products in the system.
• When connecting the optical digital output to a digital audio processor, be sure
to
make connection to the CHANGER connectors of the digital
audio processor optical digital input connectors. This arrangement allows you to enjoy Dolby Digital 5.1 Channel Surround and other effects
even when connection is made to the CHANGER connectors.
Observe the following when using Fiber Optic Cable.
• Be careful not to bend the fiber optic cable at a sharp angle.
• Do not coil the fiber optic cable smaller than a 30 mm radius.
• Do not place anything on top of the fiber optic cable.
43.EN
Advertisement
Table of Contents
