Table of Contents
Advertisement
Press ENTER.
The display will show the
Use the
DIAL
to change the gain value and watch the level of the signal on the LED ladders until the ideal values
are reached.
Then use the
PREV
figuration and the other utilities loaded in the memory).
Repeat the settings as explained above.
4.5 First Setup
At this point, the first custom setup can be prepared.
The following is only the description of setup procedure.
The detailed specifications of each parameter are shown in the respective paragraphs of the manual.
Firstly, set the following parameters
Output Pol. Polarity of the outputs
Output Gain Levels of the outputs
Note: The regulation of the MAXI-Q's parameters is closely related to the characteristics of the components
of the sound system. So if you're not the expert, please refer to the documentation and technical
specifications of your power amplifiers, loudspeaker enclosures, monitors, etc.. This will enable
you to work faster and safely.
Disable the MUTE function on the outputs you intend using and listen the sound, carry out instrumental
(if you have the necessary equipment) and any corrections required.
Then, adjust the values of the following functions:
EQ TYPE: Link or UnLink.
Graphical/Parameter EQ: 30 groups of Graphical EQ or 5 groups of Parameter EQ.
Note: In this first phase of setting up your sound system, the adjustment of these functions (which if not Indis-
pensable during installation) can wait. But do remember that adjusting the equalizers can also affect the
signal level. So if considerable equalization changes are made, remember to check and adjust the output
levels too, if necessary.
4.6 System configuration
The bold letters indicate the inputs:
A = Input A
B = Input B
Numbers
1 and 2
indicate the respective outputs.
Note:
The signal connected to Input
The signal connected to Input
INA Gain
(according to the configuration
I N A
G A I N
I N A
G A I N
and
NEXT
keys to access to the
shown
2
A
is always assigned to outputs .
B
is always assigned to outputs .
and other utilities loaded in the memory)
0
. 0 d B
-
2
INB Gain
page (if there is one, this will depend on the con-
in order:
A 1
B 2
F
D E B A S S
1
2
8
. 5 d B
(example)
checks
Advertisement
Table of Contents
