Table of Contents
Advertisement
To load a PRESET:
Use the
DIAL
to reach the required Preset.
10 Factory Presets and 128 User Presets.
Note: since the system must always be configured, there are no empty memory areas. All User areas
unused by custom
standard start configuration with all the values of the various parameters at zero.
There are 2 distinct categories of PRESETS:
Factory PRESETS
User PRESETS
Press ENTER.
The system returns to default status and the display shows the information on the PRESET that has just
been loaded.
Note:
In the example,
Loading a PRESET, a PRESET Change command is also automatically sent to the serial ports and can
be used to automatically load a PRESET with the same number to any other MAXI-Q units connected
and enabled (Refer to
When two or more
overwrites (and therefore cancels) the existing PRESET in the same memory position of the receiving
MAXI-Q
(RX).
5.1.2 Store & Naming PRESET
Use this menu to create new PRESETS, i.e. to save all the current system settings.
To save a PRESET:
Use
DIAL
to reach the memory area in which the PRESET is to be saved.
Note:
In this procedure, the
be permanently remembered that it is possible to load a
save it in a
User PRESET
Note:
Scrolling through the memory areas, the display shows the number, type and name of the
contained in them:
PRESETS
are automatically occupied by the
L o a d
P r e s e t
2 4
U
* D e f a u l t *
Factory-programmed storage.
Factory PRESETS can be used normally, temporarily modified, but can't be cancelled,
overwritten or permanently modified. Factory PRESETS contain some specific settings
for certain types of enclosures and all the system's usable configurations. For this
reason they're the ideal starting point for creating custom PRESETS.
Stored data that can be programmed by users.
User PRESETS are internal memory areas in which your own personal settings
can be saved.
A 1
2 4
U
* D e f a u l t *
User PRESET #24
, named
UTILITY
menu
- Comm. Setup
MAXI-Q
are connected, the PRESET sent by the transmitting
S t o r e
P r e s e t
U
2
* D e f a u l t *
Factory PRESET
areas aren't available, since the
area, modify it as required and then store it again in the same
P r e s e t
S t o r e
3
U
* D e f a u l t *
10
*Default* PRESET
B 2
*Default*
has been loaded.
submenu
- PRESET Change RX
Factory PRESET,
, which contains a
option).
MAXI-Q
(TX)
F
Factory PRESETS
can not
modified. Nevertheless
User
area.
PRESETS
Advertisement
Table of Contents
