Installation Requirements; Tools And Parts; Location Requirements - KitchenAid Freestanding outdoor grilll Installation And Use Manual

Tools and Parts

Gather these required tools and parts before starting installation. Gather these required tools and parts before starting installation
Read and follow the instructions provided with any tools listed
here.
Tools needed
 Phillip screwdriver
 Wrench or pliers
 Pipe wrench
P t S Parts Supplied li d
 Gas pressure regulator/hose assembly set for 11" WCP LP
gas
 Right side shelf
 Left side shelf
"AA" Battery (5)

 Warming rack
  Cooking grid Cooking grid
 Grease box
 Door hinges
 Flame tamers
 Natural gas orifice for sear side burner
Parts Needed
 20 lb LP gas fuel tank-approximately 18" (45.7cm) height.
Parts Needed for Conversion to Natural Gas
 Natural gas conversion kit Part Number 710-0003. See
"Assistance" section to order. The conversion kit includes:
 Natural gas regulator 4" W.C. (marked "Natural Gas
Regulator")
 10 ft (3.0 m) Natural gas hose with quick connector
 5.9" (150 mm) Natural gas regulator hose
 6 mm nut driver  6 mm nut driver
 6 mm wrench
 Hex key
 Gas line shutoff valve
 1/2" male pipe thread nipple for connection to pressure
regulator.
 LP gas-resistant pipe-joint compound
 CSA design-certified outdoor flexible stainless steel
appliance connector (4-5 ft [1.2-1.5 m]) or rigid gas supply
line as needed.

Installation Requirements

 Scissors or cutting pliers (to
remove tiedowns)
 Noncorrosive leak-detection
solution

Location Requirements

Select a location that provides minimum exposure to wind
and traffic paths. The location should be away from strong
draft areas. draft areas
Do not obstruct flow of combustion and ventilation air.
Clearance to combustible construction for grill:
 A minimum of 24" (61 cm) must be maintained between
the front of the grill hood, sides and back of the grill
and any combustible construction.
 A 24" (61 cm) minimum clearance must also be
maintained below the cooking surface, and the grill
shall not be used under overhead combustible
construction.
Rotisserie (accessory)*
If you equip your grill with a rotisserie, a 6" (15.2 cm)
minimum clearance is needed for the rotisserie motor.
A grounded, 3-prong outlet located to the left of the grill is
required.
*See "Assistance" section to order. See Assistance section to order.
g g
5