How To Level Your Refrigerator - Amana 12642719 Owner's Manual

Installing your refrigerator,
How to level your
refrigerator
If your refrigerator requires an ice maker
water supply connection, proceed to How
to Connect the Water Supply (page 9)
section before leveling your refrigerator.
CAUTION
To protect personal property or
refrigerator from damage, observe the
following:
➢ Protect soft vinyl or other flooring
with cardboard, rugs, or other
protective material.
➢ Do not use power tools when
performing leveling procedure.
10
cont.
MATERIALS NEEDED
➢
" hex head driver
3
⁄
8
➢ Level
1. Remove toe grille and bottom hinge
covers (see previous instructions).
2. Turn both front adjustment screws (A)
clockwise to raise and counter-
clockwise to lower.
A
3. Turn both rear adjustment screws (B)
clockwise to raise and counterclock-
wise to lower.
B
4. Turn stabilizing legs (C) clockwise
until firmly against floor.
• For Pullout Drawer Models: After
completing the above listed steps,
turn roller adjustment screws (A) 2 to
3 times counterclockwise, so that full
weight of refrigerator rests on stabi-
lizing legs.
A
5. Using a level, make sure front of
refrigerator is " (6 mm) or
1 ⁄
4
higher than back of refrigerator. See
leveling step 3 for assistance.
6. Replace toe grille and bracket
cover(s). See markings on inside of
toe grille to insure proper placement.
• Snap bottom portion into place
first. Press down on top part of grille
until top portion snaps into place.
C
bubble
1 ⁄
2