Unpacking The Pen; Installing The Penexplorer - WizCom Technologies ReadingPen TS User Manual

On the Back Panel you can see the battery compartment.

Unpacking the Pen

To get started:
1. Remove the Pen from the protective case.
2. Lift the battery cover on the back of the Pen by pushing
the tab down and out.
3. Insert the batteries into the Pen with the positive and
negative terminals corresponding to the markings on the
sides of the battery compartment.
4. Close the battery compartment.
5. Remove the protective cover from the Pen tip.
6. Turn the Pen on by pressing the red power key.
The Pen is ready to scan!
Note: Make sure that your Pen always contains batteries,
even when connected to the PC.

Installing the PenExplorer

Use the PenExplorer to download files to your Pen and to
extract the list of recently viewed words from the Pen.
Important: Do not connect the USB cable to the PC before
installing the PenExplorer.
To install the PenExplorer do the following:
1. Open a web browser and type in the following address:
http://www.wizcomtech.com/readingpents/
Download and run the file.
2. Click on the PenExplorer Installation and follow the
instructions for installing the PenExplorer and the USB
driver.
Pen Back Panel
Getting Started
5