DinFrontMount(MethodA); Installing The Unit - Jensen MP1514BT Owner's Manual

DINFrontMount(MethodA)

Installation Opening
This unit can be installed in any dashboard having an opening as shown below:

Installing the Unit

Be sure you test all connections first, and then follow these steps to install the unit.
1. Make sure the ignition is turned off, and then disconnect the cable from the
vehicle battery's negative (-) terminal.
2. Disconnect the wire harness and the antenna.
3. Press the release button on the faceplate and remove the faceplate (see
"Removing the Faceplate").
4. Remove the outer trim ring from the unit.
5. The two supplied keys release tabs inside the unit's sleeve so you can remove
it. Insert the keys as far as they will go (with the notches facing up) into the
appropriate slots at the middle left and right sides of the unit. Then slide the
sleeve off the back of the unit.
(1) Faceplate; (2) Outer trim ring;
(3) Sleeve; (4) L key; (5) R key
MP1514BT
7