RemoteControlOperation; BatteryInstallation - Jensen MP1514BT Owner's Manual

REMOTECONTROLOPERATION

BatteryInstallation

The remote control comes with a battery already
installed with a Pull Tab to prevent battery discharge.
Remove the Pull Tab before attempting to use the
remote control.
Note: The remote control will only operate this device.
It is not a universal remote control and will not
control other equipment.
Toreplacethebattery:
1. While holding the remote control, insert your
thumbnail into the battery door side notch (1) and
index fingernail into battery door upper notch (2).
Slide the battery holder open.
2. Install one CR2025 battery (1).
Note: Make sure that the proper polarity (+ or -) is
observed.
3. Slide the battery holder back into the remote control until it locks.
MP1514BT
Remote Control
Back View
Protective Pull Tab (Clear Plastic)
(1)
CR2025
3V
(1)
(2)
19