Panasonic Strada CN-NVD905U Installation Instructions Manual page 11

System-up connector
To external devices equipped with system-up connector.
Data 1 connector
(available in future)
Rear view camera
connector
Connect a rear view
camera ( page 12)
 AV connector
Data 2 connector
(available in future)
 Power connector
Fuse (3 A)
3 A
Fuse (5 A)
5 A
Noise fi lter
ANT CONT MAX 0.1 A

This lead is not intended for use with a switch actuated
power antenna.
FRONT L
FRONT R
REAR L
REAR R
AMP CONT MAX 0.1 A
To an external amplifi er or a power control lead of the TV tuner.
 Connect both the power control lead of the TV tuner and the
amplifi er control connector of the external amplifi er when the
TV tuner and external amplifi er are connected at the same
time.
PRE-OUT FRONT
PRE-OUT REAR
S.W-OUT
REMOTE-OUT
CN-NVD905U (Rear)
Fuse (15 A)
Refer fuse replacement to your nearest authorized Panasonic
Servicenter. Do not attempt fuse replacement by yourself.
Radio antenna connector (RADIO ANT IN)
This navigation system cannot be installed in a vehicle that does
not have an ACC (accessory) position on the ignition switch.
ACC 3 A
BATTERY 15 A
BATTERY 5 A
Motor antenna relay control lead (Blue)
To motor antenna (Max. 100 mA)
Front left + (White)
Front left – (White/black stripe)
Front right + (Gray)
Front right – (Gray/black stripe)
Rear left + (Green)
Rear left – (Green/black stripe)
Rear right + (Violet)
Rear right – (Violet/black stripe)
External amplifi er control power
lead (Blue/white stripe)
Pre-out connector (Front)
To an external amplifi er.
Pre-out connector (Rear)
To an external amplifi er.
Pre-out subwoofer connector
(Mono)
To an external amplifi er.
 GPS antenna
REMOTE OUT connector
To the REMOTE IN connector of a
TV tuner
Power lead (Red)
To ACC power, +12 V DC.
Battery lead (Yellow)
To the car battery, continuous +12 V DC.
Ground lead (Black)
To a clean, bare metallic part of the
car chassis.
Speaker connections
 Do not connect more than
one speaker to one set of
speaker leads (except for
connecting to a tweeter).
 Do not use a 3-wire type
speaker system having a
common earth lead.
 Use ungrounded speakers
only.
Allowable input : 50 W or
more.
Impedance : 4 – 8 
Use of speakers which
do not match the
specifi cations can cause
burning, smoking or
damage of the speakers.
11
11