Xo XOM30G User Instructions page 15

���
�
���
Fig.3: Put together the two parts
of the air deviator as shown in
picture no 3.1. It may be neces-
sary to cut the deviator to fit the
width of the chimney as shown
in picture 3.2. A sharp blade or
Hacksaw is recommended to
trim the plastic.
�
Fig.5: Fasten the air diverter
permanently to the wall with a
screw (the hole previously drilled
in Fig.2).
�����
�
Fig.4: Take the air diverter A and drill two holes as
shown in the figure (hole diameter: 1/4" inches).
Once the two holes have been drilled, fasten the
air diverter A to the bracket H.
6" ROUND
FLEXIBLE
METAL
DUCT PIPE
NOT
INCLUDED
Fig.6: Once the air diverter has been inserted
into the bracket and fastened to the wall
connect the flexible (6" Round Metal) pipe to
the diverter, use duct tape to seal
- 15 -
�
�
�
�
�
�