Sony DAV-HDX275 Operating Instructions Manual page 36

10
Press
8.
11
Connect the calibration mic to the
A.CAL MIC jack on the front panel.
Set up the calibration mic at the ear level
using a tripod, etc. (not supplied). The front
of each speaker should face the calibration
mic, and there should be no obstruction
between the speakers and the calibration
miC.
12
Press
+-1-+
to select [YES].
..
• Make sure that the headphones are not
connected to the unit or surround amplifier*.
You cannot operate following Steps with the
headphones connected.
* DAV-HDX275IDAV-HDX475 only.
13
Press
8.
[AUTO CALIBRAnON] starts.
Be quiet during the measurement.
36 GB
..
• Loud test sound is output when [AUTO
CALIBRAnON] starts. You cannot turn the
volume down. Give consideration to children
and neighbors.
• Before [AUTO CALIBRATION], install the
surround amplifier in the appropriate location. If
you install the surround amplifier in an improper
location, such as another room, proper
measurement will not be obtained. (DAV-
HDX275IDAV-HDX475 only.)
• Avoid being in the measurement area and
making noise during the measurement (which
takes about 3 minutes), as it may interfere with
measurement.
14
Unplug the calibration mic and press
+-/
~ to select [YES].
..
• The environment of the room in which the
system is installed may affect measurements.
• If measurement fails, follow the message then
retry [AUTO CALIBRAnON).
15
Press
8.
Quick Setup is finished. All connections
and setup operations are complete.
To quit the Quick Setup
Press 0 DISPLAY in any Step.
iiIiI
• If you change the position of the speakers, reset the
speaker settings. See "Getting Optimal Surround
Sound for a Room" (page 83) and "Calibrating the
Appropriate Settings Automatically" (page 84).
• If you want to change any of the settings, see "Using
the Setup Display" (page 61).
To recall the Quick Setup display
1
Press FUNCTION +/- repeatedly until
"DVD" appears in the front panel
display.
2
Press 0 DISPLAY while the system is
in stop mode.
The Control Menu display appears on the
TV screen.
3
Press -to/oJ, to select" [SETUP],
then press
8.
The options for [SETUP] appear.