How to use RGB REALITY mode
RGB REALITY mode converts RGB (primary colors) input signals into component signals and achieves the high-
quality playback by motion-image-specific picture conversion process.
This mode is effective only when the signal input is applied to the RGB input signal module (ET-MD95RGB).
The appropriate mode can be selected according to the signal. (Refer to page 64)
RGB mode: For RGB signals input from a PC etc. (mostly still images)
RGB REALITY mode: For RGB signals input from a scan converter etc. (mostly motion images)
The following are the signals that can be converted into RGB REALITY mode:
Signal name
480i
576i
480p
720/60p
1035/60i
1080/60i
1080/24p
1080/50i
1080/30p
1080/25p
1080/24sF
Others
: Supported (Factory default)
: Supported (To use the signal in the mode with
SELECTOR button and register it.)
: Use the signal in the RGB REALITY mode because the signal may not be supported depending
on the state of the signal.
: Not supported
Note
• The automatic picture adjustment (page 40) and the adjustment of the input resolution (page 59)
cannot be performed because the optimal adjustment value is preset in the RGB REALITY mode.
• The projector's adjustment functions in the RGB REALITY mode are the same as those for the YP
(or YC
C
b
66
fH(kHz)/fV(Hz)
15.73/60
15.63/50
31.47/60
45.00/60
33.75/60
33.75/60
27.00/24
28.12/50
33.75/30
28.12/25
27.00/48
) input.
r
RGB mode
RGB REALITY mode
, select the signal with the SYSTEM
Remarks
RGB mode only
P
B
R