Rear Panel Removal; Maintenance; Auger Motors; Auger Bearings & Shafts - England's Stove Works 25-PDV Installation & Operation Manual

Hide thumbs Also See for 25-PDV:

Installation and operation manual (26 pages)

Table Of Contents

Table of Contents

Available languages

CAUTION: UNPLUG THE UNIT PRIOR TO ANY SERVICE WORK!

SEE EXPLODED DIAGRAM (ILLUSTRATION 6) FOR PARTS REFERENCE

Parts Orders: (800) 516-3636

NOTE: Visit our web site for downloadable maintenance sheets and/or a service video that details

and illustrates the following maintenance tasks.

WARNING:

To perform any maintenance inside the rear of the unit, the stove must be out

(no fire), cooled down and unplugged. Electrical shock can occur if the unit is

not unplugged from power.

To remove the rear panel, simply loosen the eight (8) screws (size 5/16") and flex the panel. The

panel should come off without fully removing the screws.

Instructions for maintenance and part replacement procedures can be found on:

The Auger Motor and gearbox are one complete assembly (Part # PU-047040), and can be

removed by disconnecting the power leads and loosening the (

assembly. This bolt tightens down on the flat side of the gear shaft and locks the gear shaft and auger

shaft together – once the bolt is loosened, the entire assembly will slide from the locking collar. There

are two motor assemblies on the unit, and both rest on a shelf when not in operation. When replacing

a motor, the assembly should always be placed to rest on this shelf prior to starting the unit.

The auger bearings (Part # PU-UCF204-12) are a sealed unit and do not require lubrication. To

replace the Top Auger, all the fuel must be removed from the hopper as well as from the Top Auger

assembly. Once this is done, the four bolts that hold in the bearing can be removed, followed by the

complete auger assembly. Loosen the two (2) set screws with a 1/8" allen wrench, which will

disconnect the bearing from the shaft (the bearing assembly and auger assembly can be replaced by

reversing this procedure). When placing the auger assemblies in the unit, always tighten the four

bolts in a diagonal pattern to ensure the bearings and shafts are aligned properly.

NOTE: Follow the same procedure to work on the bottom auger, with the exception that the pellets

do not have to be removed from the hopper.

This unit is equipped with a hopper lid safety switch (Part # AC-HLSB) which is directly

connected to the top auger motor. In the event the hopper lid is left open while the stove is in

operation, the hopper lid switch will prevent the top auger from turning. This is to prevent byproducts

of combustion from entering the home through the open hopper lid and also to simply prevent

operation with the hopper lid open.

Improper hopper lid safety switch operation will result in a top auger that will not turn and

therefore a stove that will not burn. NEVER place your hand or any object near the auger while the

stove is connected to power.

IMPORTANT! READ AND FOLLOW ALL INSTALLATION AND MAINTENANCE INSTRUCTIONS, INCLUDING

CLEANING THE UNIT AS SPECIFIED, AND REPLACING GASKETS ANNUALLY, AND PARTS AS NEEDED.

ENGLAND'S STOVE WORKS IS NOT RESPONSIBLE FOR ANY DAMAGE OR INJURY INCURRED DUE TO NEGLECT, OR

DUE TO UNSAFE INSTALLATION OR USAGE OF THIS PRODUCT. CALL TECHNICAL SUPPORT WITH QUESTIONS.

MAINTENANCE

www.englanderstoves.com