Sony HVL-F43M Operating Instructions Manual page 63

5
Press the TTL/M button to display
• When
lighting ratio control.
Off-camera flash setting:
Set the wireless flash while the flash unit is attached to the camera, and then
remove it from the camera. For details, refer to the operating instructions
supplied with the external flash. When the HVL-F43M is used as the off-
camera flash, see page 57.
2
Attach the controller to the camera, and turn on the
power of the camera, controller, and off-camera flash.
3
Set up the camera with the controller and the off-
camera flash.
• See page 52 for details.
4
Make sure that the controller and the flash unit are fully
charged.
• When the flash unit is fully charged in the wireless flash mode, the AF
illuminator on the front blinks, and the TEST button is lit in amber.
5
Use test-flash to check the flash.
• The test-flash method differs depending on the camera used. For details,
refer the operating instructions of your camera.
• If the test-flash does not work, change the position of the camera, flash and
subject, or point the wireless control-signal receiver towards the camera.
Moreover, make sure that the wireless channel of the off-camera flash is set
to the same channel as the controller.
6
Check again that the controller and the flash unit are
fully charged, and press the shutter button to take the
photo.
is selected, manual setting flash is used with the
.
63
GB