Table of Contents
Advertisement
OPERATING THE TELEVISION RECEIVER
Connect your TV aerial to the aerial input socket located on the back of the TV.
Push the Main Power Switch, Power Indicator will be illuminated. After a few seconds the TV
screen will light up. Should white dots appear on the screen the TV will require tuning into the
available TV stations in your area.
Pre-setting the TV stations into the Memory
(Note: Preset tuning can only be carried out in TV Mode)
1. Press MENU button to main MENU.
2. Press the VOL button /
as shown in figure 1.
AUTO SEARCH
1. Press the CH button
memory store) mode as shown in figure 2.
2. Press the VOL button
processes, the on air stations will automatic store into
memory as shown in figure 3.
•
When scanning is completed. the set will tune to lowest
program and show lowest program number on the screen.
•
If want to stop auto search function, press menu button.
•
Press the CH button
/
to select on or off,This function use for delete some
unwant channels.
SEARCH (manual)
1. Press MENU button.
2. Press the VOL / to select TUNE
3. Press the CH
or
4. Press the VOL
or
5. When a TV station is located, the station will show.
6. Press CH / button until Program shows.
7. Press the VOL
/
To store the TV station i.e BBC1=1, BBC2=2 and so on.
8. To store the station, press the CH
button to store the station.
Repeat 2 to 7 above and store the remaining TV channels in your area.
P2120-DENVER IB(ENGLISH).p65
to select TUNE mode
To select the AUTO SEARCH (auto
to start the automatic scanning
to select the SKIP and press VOL
button and select SEARCH.
button to start searching up or down the frequency.
button and select which position.
/
button until Store shows. Now press the VOL
6
6
PICTURE TIMER
FIG .1
FIG .2
5
AUTO SEARCH
6
VHF - L
| | |
STOP MENU
FIG .3
2003/4/25, ¤U¤È 02:45
SETUP TUNE
Advertisement
Table of Contents
