Dogtek Canicom 400 User Manual page 4

If you do not hear any beep sound after inserting the battery, immediately remove it from its
housing. Check the polarity before trying again.
- Before putting the lid back in place, check that the rubber seal is in its groove.
Polarity "-" of the battery
 Activate/deactivate the remote control
Remote control is supplied with battery fitted.
▪
Activate: Press the On/Off red button ( ) located on the side of the remote control for 1 second
(ref. Diagram 2 or 3). Indications appear on the LCD screen.
▪ Deactivate: Press the On/Off red button ( ) located on the side of the remote control for 1
second. The LCD screen is off.
To increase the battery life of the remote control, we recommend you to deactivate the unit if you are not
using it for a long period.
 Activate/deactivate the receiver collar(s)
A magnet located in the remote control is used to either switch on/off the receiver collar.
▪ Activate: Approach the area where the On/Off switch magnet is located in the remote control until
coming in contact on red mark located on the collar for 1 second (ref. Diagram 7 or 8). The
indicator light on the collar will flash in green indicating that the CANICOM receiver is ready
▪ Deactivate : Approach the area where the On/Off switch magnet is located in the remote control
until coming in contact on red mark located on the receiver for 1 second (ref. Diagram 7 or 8). The
indicator light on the collar will flash from green to red and then off: the CANICOM receiver is off.
If you have several collars, renew the same procedure for each one.
To increase the battery life of the receiver collar, we recommend you deactivate the unit if you are not
using it for a long period.
 Coding of the remote control and receiver collar(s)
Each remote control has its individual radio operator code.
CANICOM 400 – user's guide – May 2009
Polarity "+" of the battery
Activate/Deactivate a receiver collar
with a CANICOM 400 remote control
Approach until coming in
contact those 2 areas
during 1 second
Diagram 7
Diagram 6
Seal
4/11