Page 1
NUM’AXES declares that the training collar DOGTEK CANICOM 200 complies to all dispositions of the part 15 of the FCC rules This device complies with part 15 of the FCC. Operation is subject to the following conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received including interferences that may cause undesired operation.
Page 2
Thank you for choosing a DOGTEK product. Before using your CANICOM 200, please read the instructions in this guide carefully and keep it for future reference. Before using CANICOM 200, we advise you to have your dog checked by your vet to ensure it is fit to wear a collar.
Checking/replacing battery of receiver collar ..............7 ▪ Changing the contact points ..................7 ▪ How to check that your CANICOM 200 is functioning properly ..........8 ▪ Getting the best results ....................8 ▪ Fitting the collar ......................8 ▪...
1 receiver collar CANICOM fitted with short contact points ▪ 1 lithium 3 Volts CR2 battery for the collar ▪ 1 remote control CANICOM 200 fitted with 1 lithium 3 Volts CR2430 battery ▪ 1 neon test lamp ▪ 1 pair of long contact points ▪...
Page 5
To increase the battery life of the receiver collar, we recommend you to deactivate the unit if you are not using it for a long period. Approach until coming in contact those 2 REMOTE areas for 1 second CONTROL Diagram RECEIVER COLLAR Coding of the remote control and receiver collar CANICOM 200 – User’s guide – May 2009 5/12...
IMPORTANT: before beginning the coding (first use of the receiver or re-coding), make sure no other person is using his CANICOM 200 or other products from the DOGTEK range close by: your receiver collar could accidentally record the code of his remote control. If that occurs, re- code the remote control with the receiver collar.
Dead battery: your CANICOM 200 functions in safety mode and the system locks up. The battery must be replaced. DOGTEK recommends using the same type and same brand of batteries as those supplied in your new purchased device. Other brand of batteries might not operate, or not be compatible or alter the performances of your collar.
These radio waves are sensitive and the range reaches approximately 250 yards (depending on geography and environment). The performance of your CANICOM 200 will be optimal if you respect the following recommendations: To obtain a good radio range, do not cover the top of the remote control unit with any part of your ▪...
The low stimulation will attract his attention; he will feel something unpleasant at the precise moment he behaves badly. ● Cautions for use Before using CANICOM 200, we advise you to have your dog checked by your vet to ensure it is fit ▪ to wear a collar.
Should your CANICOM 200 stop working or develop a problem, first read this user’s guide, then check the batteries (see § Checking/replacing battery of remote control and § Checking replacing battery of receiver collar) and replace them if necessary and retry. Also check that you are using the product correctly.
This warranty excludes: accidental damage due to dog chews, misuse, loss, or improper handling is not covered. DOGTEK will not pay for loss of time, inconvenience, loss of use of your product, or any incidental or consequential damages. Warranty is void if product resold.
Page 12
Use this space to record the serial number of your CANICOM 200 (the number is near the barcode): Transmitter: ………………………………………………………………………………………………… Receiver:…………………………………………………………………………………………………….. www.dogtek.com CANICOM 200 – User’s guide – May 2009 12/12...
Need help?
Do you have a question about the Canicom 200 and is the answer not in the manual?
Questions and answers