JETWAY G03-7F2WE-F User Manual page 18

Via cn700 chipset & via vt8237r plus chipset m/b for via c7 processor family
Table of Contents

Advertisement

This connector supports the provided IDE hard disk ribbon cable. After connecting the
single plug end to motherboard, connect the two plugs at other end to your hard disk(s).
If you install two hard disks, you must configure the second drive to Slave mode by
setting its jumpers accordingly. Please refer to the documentation of your hard disk for
the jumper settings.
(11) Secondary IDE Connector (40-pin block): IDE2
This connector connects to the next set of Master and Slave hard disks. Follow the
same procedure described for the primary IDE connector. You may also configure two
hard disks to be both Masters using one ribbon cable on the primary IDE connector and
another ribbon cable on the secondary IDE connector.
• Two hard disks can be connected to each connector. The first HDD is referred to as the
"Master" and the second HDD is referred to as the "Slave".
• For performance issues, we strongly suggest you don't install a CD-ROM or DVD-ROM
drive on the same IDE channel as a hard disk. Otherwise, the system performance on this
channel may drop.
(12) Serial-ATA Port connector: SATA1 / SATA2
This connector supports the provided Serial ATA IDE hard disk cable to connecting the
motherboard and serial ATA hard disk.
IDE1
Pin 1
IDE 2
Pin 1
14

Advertisement

Table of Contents
loading

Table of Contents