Table of Contents
Advertisement
(3) USB Port connector: UL1
The connectors are 4-pins connector that connect USB devices to the system board,
and standard RJ45 connector for Network supports 10/100 BASE-T transfer rate.
(4) Serial Port Connector (9-pin female): COM1
Serial Port connector is a 9-pin D-Subminiature connector. The On-board Serial Port
can be disabled through the BIOS SETUP. Please refer to Chapter 3 "INTEGRATED
PERIPHERALS SETUP" section for more detail information.
(5) VGA Connector (15-pin female): VGA
VGA Connector is a 15-pin D-Subminiature Receptacle connector.
This connector is for connection Monitor and System to display.
(6) TV-Out Connector: S-Video/ RCA
The S-Video/RCA Connector is for S-Video/Composite TV-Out function
RCA is setting for Composite TV-Out connector when JP3 setting 1-2 closed
RCA is setting for SPDIF-Out connector when JP3 setting 2-3 closed
(7) Audio Connector: (Line-Out/ Line-IN/ MIC)
This Connector are 3 phone Jack for LINE-OUT/ LINE-IN/ MIC.
Line-out :
Line-In :
MIC :
(8) 1394 Port1 Connector: 1394
(9) Floppy drive Connector (34-pin block): FDD
This connector supports the provided floppy drive ribbon cable. After connecting the
single plug end to motherboard, connect the two plugs at other end to the floppy drives.
(10) Primary IDE Connector (40-pin block): IDE1
Audio output to speaker
Audio input to Audio controller
Microphone Connector
PS/2
MOUSE
PS/2
Keyboard
Floppy Drive Connector
COM1
LAN
RCA
VGA
USB
SVIDEO
Pin 1
13
LINE IN
LINE OUT
MIC
1394
Advertisement
Table of Contents
