Canon PowerShot SD870 IS Digital Elph User Manual page 194

1921
Troubleshooting
Too light is shining • Change the shooting angle.
directly into the camera, or
is being reflected off the
subject.
i
.----..-----.-. - .-- ---.----- .. ---..... -- ...-..
--.~
. . ,---.--------... -- ...-..-- - ---R''' .., ....--.---.. -.---... .... --
Flash is Set to on. : • Set the flash to
y
(Flash off) (p. 71).
: • Higher ISO speeds and (High ISO
; Auto) setting may increase image
: noise, For higher image quality. use
1
as Iowan ISO speed as possible
i
(p.104L
i.ln
M,
1Ii'a.~, ~.II, ~
andD
i
modes, the ISO speed increases and
i
noise can appear.
• 1' ' ' 1 I • •
1J1••
11l~1rllR1IJill
Light from the flash has
i•
This is a phenomenon that occurs
reflected off dust particles ori with digital cameras and does not
insects in the air. This is constitute a malfunction.
particularly noticeable when
shooting using the wide
angle.
Light is reflected back from' • Turn [On) the Red-Eye setting in the
the eyes when the flash is Rec. menu (p. 86). For this mode to
used in dark areas. be effective, the SUbject must be
looking right at the red-eye reduction
lamp. Try asking them to look directly
at the lamp.
Even better results can be obtained
by increasing the lighting in indoor
settings or approaching closer to the
subject. The shutter will not activate
for approximately 1 second after the
red-eye reduction lamp fires in order
to improve the effect.
j.
You can correct red eyes in images
using the Red-Eye Correction
_ _ .... .
L_!~~~_t~~~Jp..:
__
~~~L
. .__