Assembly Procedures - Robin America RGX7100 Service Manual

7-4.ASSEMBLY.PROCEDURES
7-4-1.ENGINE.and.FRAME
(1) Attach the mount rubbers to the frame .
Insert the setting tongue of mount rubber
into the hole on the frame and tighten the
nut from the bottom of the frame .
M8 flange nut . . . 4 pcs .
Tightening.torque.:.. . 20.0-24.0. N•m.
NOTE : T here are two type of mount rubber.
Before attaching the mount rubbers,
make sure the position.
Mount rubber (M10 × 40 bolt) : place ①,②
Mount rubber (M10 × 20 bolt) : place ③,④
(2) Temporally attach the Mount Base to the
engine by inserting flange bolt into middle
hole on mount base and engine base .
Temporally fix the bolt by nut .
NOTE : M eet other side hole on the mount
base with hole of engine base. (Refer
to right side picture)
M10 flange nut &
M10 × 40 flange bolt . . . 1 pc .
.200-240. kgf•cm.
.(14.8-17.8.ft•lbs)
- 37 -
FRAME UPPER
Alternator side
FRAME
Engine side
MOUNT BASE
ENGINE