Advertisement
The Traxxas TQ Radio System
TQ Radio System Rules
Remember, always
turn the TQ
transmitter on first
and off last to avoid damage
to your Nitro 4-Tec.
18
Each time you prepare to run your Nitro
4-Tec, you must clear your frequency to
be sure no one else in the area is using
the same channel as you.
There are six possible channels,
numbered 1 through 6. Each is
represented by a color. Look at the
crystal plugged into the back of your
transmitter to determine which channel
your car is assigned to.
Always turn your TQ transmitter on first and off last. This
procedure will help to prevent your Nitro 4-Tec from
receiving stray signals from another transmitter, or other
source, and running out of control.
Always have the transmitter and receiver turned on before
you start the engine. Never turn the radio system off while
the engine is running. The on/off switch in the model only
turns the receiver on and off. It does not turn off the engine.
1
Always use new or freshly charged batteries for the radio
Channel 1
system. Weak batteries will limit the range of the radio signal
Brown
between the receiver and the transmitter. Loss of the radio
Channel 2
signal can cause you to lose control of your Nitro 4-Tec.
Red
Channel 3
Orange
Channel 4
Yellow
Channel 5
Green
Channel 6
Blue
2
3
Advertisement
