Table of Contents
Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Traxxas Nitro Rustler
Summary of Contents for Traxxas Nitro Rustler
-
Page 1: Operating Instructions
OPERATING INSTRUCTIONS COVERS MODELS 4404 AND 4410... -
Page 2: Fuel Bottle
Nitro Rustler carefully before running it. If for some reason you content however, will not deliver the same think the Nitro Rustler is not what you wanted, then do not contin- performance and tuning ease as a good, special-purpose car fuel) ue any further. -
Page 3: Battery Pack And Charger
CRYSTAL (X-TAL) - The CRYSTAL is the plug-in device that determines which channel the RADIO SYSTEM will operate on. To operate the Nitro Rustler, you will need these additional items. All For each CHANNEL, there are two CRYSTALS, one for the of these items should be available from your hobby shop. - Page 4 70/30 is the direction. You may need to adjust the corresponding trim control recommended setting while running the Nitro Rustler. after moving the servo-reversing switch. Contact Traxxas for assistance: 1-888-TRAXXAS. 972-265-8000 (outside USA). E-Mail us at support@Traxxas.com...
- Page 5 Use a small fuel bottle or bulb to put fuel into the tank. Only fill 0˚ TOE-IN the tank to the bottom of the fill neck. The Nitro Rustler can be Wheels pointing straight ahead carefully refueled while the engine is running.
- Page 6 • Use common sense whenever you are driving your model. • Do not drive the Nitro Rustler at night, on public streets, or in Intentionally driving in an abusive and rough manner will large crowds of people.
- Page 7 1) There is no longer any performance increase or 2) The engine begins to cut out at high speed or • Drive the Nitro Rustler on a flat paved surface in an oval configu- 3) The engine begins to overheat. Symptoms include: ration.
-
Page 8: Maintenance
“centering your servos on page 9). For increased stability add 1-2 degrees of toe in to each front wheel. Use the turnbuck- The ride height for Nitro Rustler can be adjusted by adding or les to adjust the alignment. removing the clip-on spring pre-load spacers. Instead of adding spacers to increase stiffness, use stiffer springs. -
Page 9: Adjusting The Slipper Clutch
Now install fresh “AA” batteries into the bat- tery holder and turn the power switch to the on position. The ser- vos will automatically jump to their center positions. Contact Traxxas for assistance: 1-888-TRAXXAS. 972-265-8000 (outside USA). E-Mail us at support@Traxxas.com... -
Page 10: Engine Troubleshooting
TRAXXAS. Drain all fuel and remove all batteries. Remember that new (before it is used), it will be repaired or replaced at Traxxas’ dis- the warranty only covers brand new products which are defective cretion.This warranty will not cover damage from wear, abuse, neglect,... - Page 11 39 Broken clutch shoe spring ........ Replace clutch shoe spring (page 13) 40 Loose flywheel ..........Replace flywheel nut (page 13) 41 EZ-Start motor pinion stripped ......Replace EZ-Start motor Contact Traxxas for assistance: 1-888-TRAXXAS. 972-265-8000 (outside USA). E-Mail us at support@Traxxas.com...
Need help?
Do you have a question about the Nitro Rustler and is the answer not in the manual?
Questions and answers