Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Traxxas 1/16 SLASH 4WD
Summary of Contents for Traxxas 1/16 SLASH 4WD
- Page 1 MODEL 70054 owner s manual ’...
- Page 2 Radio Frequency (RF) Exposure Information The radiated output power of the Traxxas LP Device is below the Industry Canada (IC) radio frequency exposure limits. The antenna for this transmitter must not be co-located with any other transmitters except in accordance with FCC and Industry Canada multi-transmitter procedures. Co-location means having a separation distance of less than 20 cm between transmitting antennas.
-
Page 3: Before You Proceed
Traxxas 1100 Klein Road accompanying materials to prevent serious damage to your All of us at Traxxas want you to safely enjoy your new model. Operate Plano, Texas 75074 model. Failure to follow these instructions will be considered your model sensibly and with care, and it will be exciting, safe, and fun Phone: 972-265-8000 abuse and/or neglect. -
Page 4: Batteries And Battery Charging
• Use the supplied charger to charge the included battery. of the installation and/or use of LiPo batteries in Traxxas products. Previous experience with radio controlled models is man No previous experience with radio See “Charging the Battery Pack”... -
Page 5: Tools, Supplies, And Required Equipment
This will prevent air bubbles. Placing both ends of the decal down and then trying to smooth it out will result in air pockets. Look at the photos on the box for typical decal placement. 1/16 SLASH 4WD • 5... -
Page 6: Product View
ANATOMY OF THE 1/16 SLASH 4WD Battery Compartment Vent Hex Hub Rear Half Shaft Battery Door Release Tab Turnbuckle Pivot Ball Antenna Mount Rear Body Axle Carrier Battery Compartment Door Mount LED Light Pipe Turnbuckle Rear Bumper Receiver Box Push Rod... -
Page 7: Quick Start: Getting Up To Speed
6. Turn on the radio system • See page 13 Make a habit of turning the transmitter on first and off last. Look for the Quick Start logo at the bottom of Quick Start pages. 1/16 SLASH 4WD • 7... -
Page 8: The Traxxas Tq 2.4Ghz Radio System
When flow is constricted, energy is converted to heat and is the electronic motor control inside the model. Electronic speed lost. Traxxas power systems are optimized to reduce electrical controls use power more efficiently than mechanical speed resistance and the resulting power-robbing heat. - Page 9 THE TRAXXAS TQ 2.4GHz RADIO SYSTEM Transmitter - The hand-held radio unit that sends throttle and IMPORTANT RADIO SYSTEM PRECAUTIONS steering instructions to your model. • For maximum range, always point the front of the transmitter To prevent loss of radio range, toward the model.
-
Page 10: Transmitter And Receiver
THE TRAXXAS TQ 2.4GHz RADIO SYSTEM Your model is equipped with the Traxxas TQ 2.4GHz transmitter. RADIO SYSTEM WIRING DIAGRAM XL-2.5 Wiring Diagram The transmitter has two channels: Channel one operates the Channel 1 steering, and channel two operates the throttle. The receiver Steering Servo inside the model has three output channels. -
Page 11: Installing Transmitter Batteries
THE TRAXXAS TQ 2.4GHz RADIO SYSTEM INSTALLING TRANSMITTER BATTERIES INSTALLING THE RECEIVER ANTENNA Your TQ 2.4GHz transmitter uses 4 AA batteries. The battery The receiver antenna and antenna tube To prevent loss of radio range, Antenna compartment is located in the base of the transmitter. - Page 12 50+mph by connecting the batteries in series using Traxxas High-Current Connector. Standard green on the transmitter, a Traxxas series connector (Part #3063, sold separately). This also connectors restrict current flow and are not check the polarity of the requires a gearing change as described on page 23.
-
Page 13: Radio System Basic Adjustments
THE TRAXXAS TQ 2.4GHz RADIO SYSTEM RADIO SYSTEM CONTROLS RADIO SYSTEM BASIC ADJUSTMENTS Steering Trim Make certain the model’s The steering trim knob located on the face of the receiver antenna is properly transmitter adjusts the neutral (center) point of the steering installed before operating channel. -
Page 14: Using The Radio System
THE TRAXXAS TQ 2.4GHz RADIO SYSTEM 7. Gently operate the throttle trigger to ensure that you have USING THE RADIO SYSTEM forward and reverse operation, and that the motor stops when The TQ 2.4GHz Radio System has been adjusted at the factory Using Reverse: While driving, the throttle trigger is at neutral. - Page 15 THE TRAXXAS TQ 2.4GHz RADIO SYSTEM Higher Speeds Require Greater Distance TRANSMITTER LED CODES The faster you drive your model, the more quickly it will near the LED Color / Pattern Name Notes Failsafe limit of radio range. At top speeds, models can cover anywhere...
-
Page 16: Adjusting Electronic Speed Control
On high- traction surfaces, this could result in transmission or driveline damage. 16 • 1/16 SLASH 4WD... - Page 17 3. When the LED blinks RED TWICE, Release Solid Red battery with too high voltage (3S LiPo) is used, the XL-2.5 will go into a failsafe release the EZ-Set button. mode. The XL-2.5 is only compatible with 2S LiPo. 1/16 SLASH 4WD • 17 *Patent-pending...
-
Page 18: Running In Wet Conditions
Do not run your model in wet conditions if you are not willing to the methods with which they can be charged, it’s impossible to accept the additional care and maintenance responsibilities. give exact run times for the model. Another major factor that affects 18 • 1/16 SLASH 4WD... - Page 19 (run the motor slowly) until the excess water can run out. Applying full • The Traxxas TQ 2.4GHz transmitter is not water resistant. Do not throttle to a motor full of water can cause rapid motor failure. Your subject it to wet conditions such as rain.
-
Page 20: Maintaining Watertight Seal
Refer to your exploded view diagrams for speed control leads and antenna wire (B). help with disassembly and reassembly. 3. Apply a small bead of silicone grease (Traxxas • Transmission: Remove, disassemble, part #1647) to the wire clamp (C). -
Page 21: Tuning Adjustments
6. Slowly thread the upper cap with the installed shock bladder vehicle’s handling for your particular surface. onto the shock body. The excess oil will bleed out of the small hole in the shock cap. 7. Tighten the shock cap until snug. 1/16 SLASH 4WD • 21... -
Page 22: Transmission Tuning
Turn the adjustment nut clockwise to tighten (less slippage) and counterclockwise to loosen (more slippage). Tuning the Sealed Gear Differentials The 1/16 Slash 4WD’s front and rear gear differentials allow the left and Positive camber right wheels to spin at different speeds while turning so that the tires do not scuff or skid. -
Page 23: Motor Installation
Extensive testing has been done to determine the best gear ratios 13.20 1. Remove the motor as described 11.45 12.60 for the 1/16 Slash 4WD. The stock gearing balances power, speed, in Motor Installation. 10.96 12.05 and efficiency to optimize the performance of the model. However, 2. -
Page 24: Wheels And Tires
If you wish to install tires with a diameter greater than 4 inches or 100mm, Traxxas suggests you configure the transmission for ”underdrive” gearing. Details on making this simple modification are available at Traxxas.com. -
Page 25: Maintaining Model
If the bottom of the shock is leaking, then it 4. Check the wiring for any frayed wires or loose connections. is time for a rebuild. The Traxxas rebuild kit for two shocks is 5. Check the mounting of the receiver and servo(s) and part #7062. - Page 26 ’ MODEL 70054 1100 Klein Road, Plano Texas 75074 1-888-TRAXXAS 130117 70054OM-N-EN-R00...