Traxxas 41096-3 Operating Instructions Manual
Traxxas 41096-3 Operating Instructions Manual

Traxxas 41096-3 Operating Instructions Manual

Nitro stampede

Advertisement

Quick Links

OPERATING INSTRUCTIONS
MODEL 41096-3
KC2307-R00 150626

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 41096-3 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Traxxas 41096-3

  • Page 1 OPERATING INSTRUCTIONS MODEL 41096-3 KC2307-R00 150626...
  • Page 2: Personal Safety Precautions

    Make sure to read and follow all instructions and precautions that were provided adult. Traxxas shall not be liable for any loss or damages, whether direct, indirect, special, with the battery packs and your charger. It is your responsibility to charge and care for the incidental, or consequential, arising from the use, misuse, or abuse of this product and any battery packs properly.
  • Page 3: Fuel Bottle

    2. Small Phillips-head and flat-head screwdrivers (for adjustments) Menu Button 3. After-run oil (to protect the engine from corrosion) Traxxas TQi Radio System Your model includes the latest Traxxas TQi 2.4GHz transmitter with Traxxas Link ™ Model Memory. The transmitter’s easy-to-use design...
  • Page 4: Installing Transmitter Batteries

    From the factory, the Multi- 2. Insert the antenna tube into the antenna mount, taking Function knob controls Traxxas Stability care not to crimp the antenna wire. To prevent loss of Management (TSM). For more detail on TSM, refer to page 5.
  • Page 5 If the wheels are turned slightly to the Traxxas model by helping you left or right, turn off TSM and slowly adjust the steering trim to maintain control of the vehicle in low-traction situations. TSM control on the transmitter until they are pointing straight ahead;...
  • Page 6: Preparing To Run

    1. Press the tab in the end of the battery compartment running the engine. For the best filtration, use the door to open. (A) type of oil made for foam air filters. Traxxas air filter 2. Plug a fully charged 7.2-volt battery pack oil is recommended (part #5263). Lightweight motor into the connector inside.
  • Page 7: Driving Precautions

    Breaking-in the Engine Low-Speed Mixture Setting (Very Important!) This screw meters the fuel at low speeds. The low-speed mixture Once your engine is running, it must be broken-in. The key to screw is located in the end of the carburetor, inside the throttle breaking-in your engine is patience.
  • Page 8 Tanks Two Through Four: Low-Speed Fuel Mixture Adjustment Shut off the engine and The low-speed mixture is always set after the high-speed needle is turns out allow it to cool for 5-10 correctly adjusted. The low-speed mixture will be set using the pinch test. minutes, then refuel.
  • Page 9 Tuning the Engine by Temperature The following procedures require an optional infrared temperature probe, an on-board temperature gauge, or the Traxxas telemetry temperature sensor (part #6521). The engine can be used as an effective tuning aid when you understand the relationship between engine temperature and ambient temperature.
  • Page 10: Maintenance

    After-Run Procedure Adjusting the Slipper Clutch The Nitro Stampede features an adjustable slipper clutch on the spur You must perform after-run maintenance on your engine whenever gear to protect the drivetrain from sudden shock loads (such as landing the model will be stored for longer than a few hours. Taking the time to off of jumps with the engine at full throttle).
  • Page 11 After-run Procedure Piston stuck at “top dead center” (TDC) You must perform after-run maintenance on your Traxxas engine “Top dead center” is the position where the piston is at the very top of whenever the model will be stored for longer than a few hours. Taking the the tapered sleeve.
  • Page 12: Tqi Advanced Tuning Guide

    (set to Traxxas Stability Management (TSM) by default, see page 5). drive throughout the rest of the course. Reducing steering throw can...
  • Page 13 Model Lock Note: To unlock a memory, press SET twice at step 5. The LED will The Traxxas Link Model Memory feature can store up to thirty blink rapidly green to indicate the model is unlocked. To unlock all models (receivers) in its memory. If you bind a thirty-first receiver, models, press MENU twice at step 6 and then press SET.
  • Page 16 The Traxxas Link Wireless Module is sold separately (part #6511). The Traxxas Link application is available from the Apple App store for iPhone, iPad, or iPod touch and on Google Play for Android devices. iPhone, iPad, iPod touch, or the Android device are not included with Intuitive iPhone, iPad, iPod touch, and Android interface the Traxxas Link Wireless Module.

Table of Contents