Icom IC-7200 Installation Manual page 18

FOR YOUR REFERENCE
About audio (Continued)
USB level setting
Set the input modulation level of the USB jack in the set mode item 'USB Level' or CI-V system (command).
<Set mode>
M-CH/RIT
q Push and hold
the set mode.
w Rotate [M-CH] to select "USB LVL."
e Rotate [DIAL] to set the input modulation level of
the USB jack within 0% to 100% in 1% steps.
M-CH/RIT
r Push to exit the set mode and return to
SET
normal operation.
<CI-V system>
Send the command "FE FE 76 E0 1A 03 25 0128 FD"* to the transceiver from the PC.
• 0000 (0%) to 0255 (100%) can be set as the input modulation level.
* The transceiver's address is described as "76," the controller's address is described as "E0" and input modula-
tion level is described as "0128 (50%)" for examples in this guide.
The modulation input audio format
The modulation input audio format from the USB jack is listed as below.
Modulation input
* The sampling rate other than those above can be used according to the application.
[Installed audio player] (Windows standard software, etc.)
When using the audio software (e.g. Windows standard software; Microsoft
operations can be performed;
• Received audio output to the PC.
• Modulation input from the PC.
PC software (third party) is additionally required when the following operations are performed;
• Monitoring the received audio with the speaker that is connected to the PC.
• Modulation input for the PC microphone's audio.
for 1 sec. twice to enter
SET
50% (default)
Input modulation level
The number of data bit
Sampling rate*
The number of channel
16-bit
32/44.1/48 kHz
Monaural (Stereo: The audio signal from L is input.)
18
NB
V/M
MW
COMP
MODE TS
RIT
GENE
TUNER FILTER
P.AMP
ATT
M-CH/RIT
SPCH
SET
[DIAL]
® Sound Recorder, etc.), the following
NR ANF
METER
1 A/B 2 3
SPLIT
1.8 = 3.5 7
4 5 6
M-CL AGC
10 14 18
7 8 9
SCAN VOX
28
21 24
.
0 F-INP ENT
MNF
50
BAND
[M-CH]