Skier's Choice Supra 2014 Owner's Manual page 80

Main Dash Power-Circuit Breaker - Battery Connection
Main Ballast Power-Circuit Breaker - Battery Connection
— 80
Fuse Panel - Back of Engine
Fuse Panel - Under Dash
The Power Distribution Module (PDM) has an internal circuit protection
for the Vision system and other components controlled through the Vision
system. There are two PDM's in the 2014 Supra models; one under the
dash that controls the forward components on the Vision system. The
second PDM is located on the transom and controls the ballast, wake
plate, and underwater lights.
The power to each PDM is protected by its own circuit breaker. The
dash PDM has a breaker also under the dash. The circuit breaker for the
transom PDM is located on the inside of the port engine panel close to
the floor.
To turn off the power to the PDM's, manually press the red button and the
circuit breaker reset lever will flip down and the power to the PDM's will
be shut off. To reset the circuit breaker, push the reset lever back up.
The power to the dash circuit is protected by a circuit breaker that is located in the
observer seat storage area near the battery.
To turn off the power to the dash, manually press the red button and the circuit breaker
reset lever will flip down and the power to the dash circuit will be shut off. To reset the
breaker, push the reset lever back up.
If all of the dash switches fail to work, reset the main dash power-circuit breaker.
The power to the ballast pump circuit is protected by a circuit breaker that is located in
the port side of the engine compartment.
To turn off the power to the ballast pump, manually press the red button and the circuit
breaker reset lever will flip down and the power to the ballast circuit will be shut off. To
reset the breaker, push the reset lever back up.
PDM Breaker
Fuse Panel - Battery Connection
© 2014 Skier's Choice, Inc.