Skier's Choice Supra 2014 Owner's Manual page 50

2014 Ballast Trouble Shooting Guide
Problem
Pump will not turn on
Pump will not turn on
Pump will not turn on
Pump turns on, but does
not pump water
— 0
© 2014 Skier's Choice, Inc.
Possible Cause Action
Ballast power wires not Check ballast power wires
connected to battery at battery
Ballast breaker is tripped Check 60 amp ballast breaker
at the battery
System needs reset Check power to all areas
Pump not priming (1) Water intake ball valves are not
open
(2) Kink in hose
2014 Supra Ballast Fill Times
Boat Model
SC- Standard
SC-Optional Flex
SA-Standard
SA-Optional Flex
Sunsport 242
Launch 242
DC Outlet
Correction
Connect power wires to battery
Reset ballast breaker at battery
Turn power off to the system at the breaker
and then back on and retry
(1) Open ball valves
(2) Check hoses for kinks and straighten
as needed
(3) Check hose connections and tighten if
loose.
(4) Replace Impeller
Front Ballast Rear Ballast Time
4.5 minutes 2.5 minutes
10.5 minutes 6 minutes
4.5 minutes 2.5 minutes
10.5 minutes 6 minutes
4 minutes 6 minutes
8.5 minutes 6 minutes
For your convenience, a DC outlet has been included
on the panel to the right of the driver's seat. Some
models have receptacles located in the glovebox.
Location varies by model.
0 —
© 2014 Skier's Choice, Inc.