Component Description - Ice-O-Matic MFI Service And Installation Manual

MFI Series
●Control Box: Contains the electrical controls that operate the machine.
●High Pressure Cut Out Switch: An auto-reset switch sensing the high side refrigeration pressure. It will
shut the machine off if the discharge pressure exceeds 450 psig.
●Low Pressure Cut Out Switch: An auto-reset switch sensing the low side refrigeration pressure. It will
disconnect power to the circuit board and shut down the machine if the low pressure falls too low.
●Evaporator: A vertical stainless steel tube, refrigerated and water filled. Utilizes a stainless steel auger.
●Compressor: The refrigerant vapor pump.
●Water Reservoir: Float operated, it maintains the water level in the evaporator at a constant level, and it
also contains the water level sensor.
●Water Level Sensor: Senses if there is water in the reservoir to make ice out of. Will shut the ice machine
off if there is no water in the reservoir.
●Ice Discharge Chute: Directs the ice produced by the evaporator into the storage bin.
●Ice Level Sensor: An "electronic eye", it senses the presence of ice in the bottom of the discharge chute.
●Gear Motor: An oil filled, speed reduction gearbox, driving the auger.
●Drain Tube: When uncapped and lowered, drains the evaporator.
●Condenser: Air or water cooled, where the heat removed in ice making is discharged.
●Expansion Valve: The refrigerant metering device.
High
Pressure
Cut Out
Control Box
Condenser
Compressor
Page 10

Component Description

Air Cooled Model Shown
Expansion Valve
Ice Discharge Chute
Ice Level Sensor
Water Reservoir
Drain Tube
Gear Motor