Powering Up The System; Quick Check - Gateway ALR 7200 User Manual

Warning!
The bezel door must be
closed and locked while the
system is running.
Important!
Under no circumstances
return any equipment
without obtaining a Return
Material Authorization
(RMA) number.
6 Gateway ALR 7200 User's Guide

Powering up the system

Look through this section before you turn on the server. You may be able to
solve any problems you have at initial startup by verifying that the server
setup has been completed correctly.
Press the on/off switch on the front panel, and the green LED on the front
panel lights.
If you turn off the system, you must wait at least ten seconds before you
turn the system back on.
The system self-checks the memory even if the monitor is not connected. If
the monitor is connected and powered on, the screen displays the power-up
sequence.
•
If more than one processor is installed, the system displays which
processor it is currently testing.
•
If any errors are encountered, the server displays them on the
monitor.
•
If a monitor is not connected or the system is unable to display an
error, an error beep code sounds.
•
If the system encounters an error, it is most likely a nonfatal one,
meaning the system will function until the error can be corrected
(usually through the BIOS Setup).

Quick check

If the system does not operate correctly, re-read the instructions for any
procedure(s) you have performed. If an error occurs within an application,
consult the documentation supplied with the software.
This section identifies solutions to common problems. If the suggestions in
this section are not helpful, try looking up the problem in the Maintaining
and Troubleshooting the ALR 7200 Server. In the event of a problem, the
following checks should be performed: