IBM Netfinity User Manual page 29

• If your computer is configured with a LAN on motherboard (LOM) and you
have not added that LOM to any team, the following window opens when you
try to close the Failover Team Configuration tab:
• Click OK.
• If you originally chose not to use the LOM as part of your Failover Team (see
Step 5 on page 1-15), the above window will not open.
• When team configuration has been correctly performed, one "Virtual Team"
adapter device driver is created for each configured team and is displayed with
the other adapters in the Network window of the Control Panel.
7. In the Network window, click Close.
8. Configure the Team IP address, if necessary.
If other adapters in your system use TCP/IP bindings, the TCP/IP Properties window
opens. Configure the IP address and any other necessary TCP/IP configurations for
the team. Click OK when you are finished.
9. When you are prompted to restart your computer, click Yes.
The computer restarts, using the new configuration settings.
Note: If you modify any optional configuration parameters (Failover Team or
VLAN), you must restart your computer before the changes will take effect. If
you make changes and do not restart, you might experience configuration
problems. If no configuration changes have been made, you can click No to
close the configuration session without restarting your computer.
Removing adapters from a team
To remove an adapter from its assigned Failover Team, do the following:
1. Access the Failover Team Configuration tab.
2. Select the adapter in the team list; then click Remove NIC.
The adapter is removed from the team list and is displayed in the NICs Available list.
Note: If you remove a LAN on motherboard (LOM) from a Failover Team, you must
also delete the team. If you do not add the LOM back to the team or delete the
team, you cannot successfully complete adapter configuration.
1-17
User's guide