System Requirements - IBM Netfinity User Manual

LED
1000 Off
100 On
100 Off
10 On
10 Off
If all four LEDs remain lit simultaneously, the adapter driver software is either missing or
improperly installed.

System requirements

Before installing the Netfinity Gigabit Ethernet Adapter, be sure your computer meets the
following requirements:
• Hardware:
— Intel Pentium
requirements
— One open 32- or 64-bit PCI slot
— 128MB RAM
• Software:
— Operating system: Microsoft Windows NT 4.0 (server or workstation) with
Service Pack 4 or later
— Adapter software: IBM Netfinity Gigabit Ethernet Adapter device driver
software (included), version 2.3 (or higher) for Windows NT. See the Netfinity
Gigabit Ethernet Adapter CD for these files in the \nt40 directory:
– ALTNDIS.SYS (network device driver file)
– ALTVLAN.SYS (intermediate device driver file)
– ALTDLG.DLL (information used by the installation program)
– OEMSETUP.INF (information file)
1-4
Netfinity® Gigabit Ethernet Adapter User's guide
State
No 1000 Mbps link: possible link at different speed,
possible bad cable, bad connector, or configuration
mismatch.
Good 100 Mbps Ethernet link.
No 100 Mbps link: possible link at different speed,
possible bad cable, bad connector, or configuration
mismatch.
Good 10 Mbps Ethernet link.
No 10 Mbps link: possible link at different speed, possible
bad cable, bad connector, or configuration mismatch.
®
-based computer that meets Microsoft
Description
®
Windows NT
®
4.0