Resetting The Lamp Timer; Using The Security Lock - IBM iLC300 User Manual

10. Reset the lamp hour timer.

Resetting the lamp timer

If the lamp timer has reached the maximum number of hours for the projector
lamp (3,000 hours), the LED on the projector's keypad will show a lamp error (see
Appendix B, "Troubleshooting your setup", on page 27). To reset the lamp age,
simultaneously hold down the two Volume keys on the projector's keypad for 10
seconds. At that point the LED will turn green and you can power on the projector.
You can also navigate to the Settings -> Service menu and select Lamp Reset to
reset the lamp timer.

Using the security lock

The projector has a security lock for use with a PC Guardian Cable Lock Refer to
the information that came with the lock for instructions on how to use it.
26
IBM iLC300 Conference Projector: IBM iLC300 Conference Projector User's Guide
8. Replace the lamp door by sliding the tabs into the tab bays and tightening the
two screws.
9. Plug in the power cable, then press the Power button to turn the projector
back on.
Y
audio in
computer 2
computer 1
Pb
audio in
computer in
Pr
1 Security lock
video
R
monitor out
s-video
network
R
audio in
L
serial control
audio out
L