Displaying A Video Image - IBM iLC300 User Manual

described directly above (the yellow connectors on the video cable are not used).
If the video device uses component cable connectors (sold separately), plug the
cable's green connectors into the green component-out connector on the video
device and into the green component connector (labeled Y) on the projector. Plug
the component cable's blue connectors into the blue component- out connector on
the video device and into the blue component connector (labeled Pb) on the
projector. Plug the component cable's red connectors into the red component-out
connector on the video device and into the red component connector (labeled Pr)
on the projector. Use the video cable's audio connectors as described directly above
(the yellow connectors on the video cable are not used).

Displaying a video image

To display a video image:
1. Remove the lens cap.
2. Press the Power button on the top of the projector.
3. Plug in and turn on the video device.
4. Position the projector the desired distance from the screen at a 90 degree angle
5. Adjust the zoom or focus rings by rotating them until the desired image size
6. If the image is not square, adjust the keystone using the buttons on the keypad.
7. Adjust the volume on the keypad or the remote.
10
IBM iLC300 Conference Projector: IBM iLC300 Conference Projector User's Guide
The LED flashes green and the fans start to run. When the lamp comes on, the
startup screen is displayed and the LED is steady green. It can take a minute
for the image to achieve full brightness. If you do not see a startup screen see
Appendix B, "Troubleshooting your setup", on page 27.
The video device's image should appear on the projection screen. If it does not,
press the Video button.
to the screen.
and sharpness are produced.
Press the upper Keystone button to reduce the upper part of the image, and
press the lower Keystone button to reduce the lower part.
video
R
Y
audio in
computer 1 computer 2
s-video
R
Pr
audio in
audio in
L
computer in
audio out
L
Pb
video
R
Y
audio in
computer 1 computer 2
s-video monitor
network
R
Pr
audio in
audio in
L
computer in serial control
audio out
L
Pb
monitor
network
serial control