Vais Technology SoundLinQ3 Owner's Manual page 7

Installation
CD-MP3 Emulation Mode Selection (CD-MP3 emulation)
CD-MP3 Emulation Mode programming steps:
@
Properly install this unit.
@
Put "Left" programming switch in "DOWN" position.
@
Put ignition switch into the "ACC" position.
@
Wait for long beep followed by a few short beeps. This may take up to one minute.
@
Return programming switches into their default position (both switches "UP").
Wait up to 30 seconds until confirmation beep.
@
Put ignition switch into the "OFF" position. Wait at least 10 seconds.
@
Put ignition switch into "ACC" or "ON" position.
@
Check SoundLinQ for functionality, especially TEXT capabilities.
1 2
ON
Ignition into
"ACC" or "ON"
Left switch
position
"DOWN"
Mounting unit using Velcro fasteners
NOTE
!
Velcro Fasteners are not included
!
VAIS Technology strongly recomand to ground unit to the car chassis for best results
1 2
ON
Both switches
Confirmation beep
"UP"
(Red LED blinks)
SoundLinQ3
"Hard" Velcro Fastener
"Soft" Velcro Fastener
Carpet or car chassis
up to 30 sec
Confirmation beep
(Red LED blinks)
7
Ignition into
up to 10 sec
"OFF" position