NOBOCOOL NC-42CP User Manual page 13

COOLING MODE
(Fig. 16)
Press the " ON /OFF" button to turn the appliance on.
Press the "MODE" button to select COOL.
Set the temperature using the "
To select fan speed, press the "FAN" button repeatedly
until the required speed is selected ( HIGH, MED, LOW, AUTO ).
NB: In COOLING mode, the appliance automatically removes excess
moisture from the atmosphere.
NB: In COOLING mode, the exhaust hose must be connected to allow warm
air to be expelled from the room being cooled.
DRY MODE
(Fig. 17)
When used as dehumidifier only, keep the air exhaust hose disconnected.
Press the "ON /OFF" button to turn the appliance on.
Press the " MODE " button to select DRY, the fan speed will always be
at AUTO and cannot be adjusted in DRY mode.
FAN MODE
(Fig. 18)
Press the "ON /OFF" button to turn the appliance on
Press the "MODE" button to select FAN .
To select fan speed, press the "FAN" button repeatedly until the required
speed is selected ( HIGH, MED, LOW ). Fan speed AUTO can not be selected.
NB: In FAN mode, the exhaust hose does not need to be connected.
SETTING THE TIMER
This timer can be used to delay the appliance start up or shutdown.
This avoids wasting electricity by optimising operating periods.
PROGRAMMED SHUTDOWN
With the appliance on, press the "TIMER" button, the time and
the "h" symbol are displayed.
Set the time remaining until shutdown with the "
(from 30 minutes to 24 hours).
During the first ten hours you can select half hour intervals. For times longer
than ten hours, one hour intervals can be selected
Press the "TIMER" button again to confirm the timer setting, the TIMER INDICATOR LIGHT lights up
and keeps flashing to indicate the timer is activated.
At the end of the set time the appliance switches off automatically.
To cancel the TIMER setting, press the " TIMER " button again.
PROGRAMMED STARTUP
Turn on the appliance and select the required mode, for example Cooling mode, 25°C, fan speed HIGH.
Press ON/OFF button to switch into STANDBY.
Press the "TIMER" button twice , the time and the "h" symbol are displayed.
Set the time remaining until startup with the "
During the first ten hours you can select half hour intervals. For times longer than ten
hours one hour intervals can be selected.
Press the "TIMER" again to confirm the timer setting, the TIMER INDICATOR LIGHT lights up
and keeps flashing to indicate the timer is activated.
At the end of the set time the appliance switches on automatically and operates in the selected mode,
for example Cooling mode, 25°C, fan speed HIGH.
To cancel the TIMER setting, press the " TIMER " button again.
" button.
(Fig. 19)
" buttons
" buttons (from 30 minutes to 24 hours) .
12
TIMER ON TIMER OFF
COOL
AUTO
HIGH
DRY
MED
FAN
LOW
SWING
Fig. 16
TIMER ON TIMER OFF
COOL
AUTO
DRY HIGH
FAN MED
LOW
SWING
Fig. 17
TIMER ON TIMER OFF
COOL
AUTO
HIGH
DRY
MED
FAN
LOW
SWING
Fig. 18
TIMER ON TIMER OFF
COOL
AUTO
h
DRY HIGH
FAN MED
LOW
SWING
Fig. 19
NOBOCOOL NC-42CP/C