NOBOCOOL NC-42CP User Manual page 11

COOLING MODE
Press ON/OFF button to turn the appliance on.
Press MODE button to select COOLING mode.
Set the temperature with INCREASE/DECREASE buttons.
To select fan speed, press
(High/Med/Low/Auto). Auto fan speed adjusts the fan speed automatically between HIGH, MEDIUM
and LOW settings according to the variance between set temperature and room temperature.
After displaying the set temperature for 10 seconds, the control panel displays the room temperature.
NB: In COOLING mode, the appliance automatically removes excess moisture from the atmosphere.
NB:
In COOLING mode, the exhaust hose must be connected to allow warm air to be expelled from the room being cooled.
DRY (DEHUMIDIFYING) MODE
Keep the windows and doors closed for an effective dehumidification.
When used as dehumidifier only, keep the air exhaust hose disconnected from the back of the unit.
Press ON/OFF button to turn the appliance on.
Press MODE button to select DRY mode, the fan speed will always be at Auto and can not be
adjusted in DRY mode and the control panel will display "dh".
Compressor light will be permanently illuminated in this mode after approximately 3 minutes.
FAN MODE
Press ON/OFF button to turn the appliance on
Press MODE button to select FAN mode.
To select fan speed, press FAN SPEED button repeatedly until the required speed is selected (HIGH,
MED, LOW). The fan speed AUTO can not be selected in FAN mode.
NB: In FAN mode, the exhaust hose does not need to be connected.
SETTING THE TIMER
This timer can be used to delay the appliance start up or shutdown. This avoids wasting electricity by optimizing
operating periods.
PROGRAMMED SHUTDOWN
With the appliance on, press TIMER button, the time remaining until shutdown is displayed on LCD.
Set the time when you want the appliance to switch off with INCREASE and DECREASE buttons
(from 30 minutes to 24 hours).
During the first ten hours you can select half hour intervals. For times longer than ten hours, one hour
intervals can be selected.
Press TIMER button again to confirm the timer setting, the TIMER INDICATOR LIGHT lights up and
keeps flashing to indicate the timer is activated.
At the end of the set time the appliance switches off automatically.
To cancel the TIMER setting, press TIMER button again.
PROGRAMMED STARTUP
Turn on the Appliance and select the required mode, for example, COOLING 25° C, fan speed HIGH.
Press ON/OFF button to switch into STANDBY.
Press TIMER button, the time is displayed on LCD display.
Set the time remaining until startup with INCREASE and DECREASE buttons, (from 30 minutes
to 24 hours).
During the first ten hours you can select half hour intervals. For times longer than ten hours one hour
intervals can be selected.
Press TIMER button again to confirm the timer setting, the TIMER INDICATOR LIGHT lights up and
keeps flashing to indicate the timer is activated. The time remaining (in hours) will also be shown
on LCD display.
At the end of the set time the appliance switches on automatically and operates in the selected mode,
for example COOLING 25°C, fan speed HIGH.
To cancel the TIMER setting, press the " TIMER " button again.
FAN SPEED button repeatedly until the required speed is selected
10 NOBOCOOL NC-42CP/C