Fisher & Paykel WH60F60W2 Installation Instructions And User Manual page 7

Inlet hoses
The appliance must be connected to the water mains using new hose sets. Old hose sets should
not be reused.
Connecting the hoses:
1 Connect the straight ends of the inlet hoses to the taps. There are washers fitted to both ends.
2 Connect the elbow ends of the inlet hoses to the inlet valves on the back of the machine. The
cold inlet valve is marked in blue, while the hot inlet valve is marked in red.
Cold supply only
If you only have a cold water supply, an inlet valve cap (blanking cap) MUST be connected to the
hot inlet valve. This prevents water leaking out of the hot inlet valve. The cap is supplied in the
same bag as the inlet water hoses.
Installation instructions
6