IBM 8260 Installation Instructions Manual page 21

Installation Instructions
2.8 .1.3 Migration of PEER GROUP 2 - HUB c
--- ATM ADDRESS SETTING ---------------------------------------------------
After having completed the swap, the ATM address has been migrated to the Node-0
ATM address, but the PNNI Summary Address was set to a default value. So you need
to enter the old ATM address again, with a new selector, by issuing the following
command :
o HUBc>set pnni node_0 atm_address:
39.99.99.99.99.99.99.00.00.77.77.02.01.00.00.82.60.02.01.01
o HUBc>SHOW FUTURE_PNNI NODE_0
Check your new ATM address.
o HUBc>COMMIT PNNI, the 8260 will be reset
The telnet session if any is broken.
Login as ADMINISTRATOR on the 8260 console.
o HUBc>SHOW PNNI NODE_0
Check your ATM address. It will display information about : LEVEL
ID, PEERGROUP ID, NODE ID.
--- PORT SETTING ----------------------------------------------------------
After having completed the swap, all the NNI ports will become disa-
bled IISP ports, so you need to re-enable them : enable all your old
NNI ports (now IISP) as VOID ports.
1. HUBc>SET PORT 4.1 ENABLE VOID
2. Because in the example the vpc between hubc and hubd is ZERO, you can
define the port 5.1 as IISP:
HUBc>SET PORT 5.1 ENABLE IISP
3. SETTING FOR UNI PORT. No change is needed for the port set as UNI
before the migration.
PN : 26L0227 EC : F34705 June 17 1998
Copyright IBM Corp. 1998
Page 21