Note For Repair; Subsidiary Materials - Sony SLT-A33 Service Manual

NOTE FOR REPAIR

• Make sure that the flat cable and flexible board are not cracked or
bent at the terminal.
Do not insert the cable insufficiently nor crookedly.
• When remove a connector, do not pull at wire of connector. It is
possible that a wire is snapped.
• When installing a connector, do not press down at wire of connector.
It is possible that a wire is snapped.
• Do not apply excessive load to the gilded flexible board.
DISCHARGING OF THE CHARGING CAPACITOR
The charging capacitor is charged up to the maximum 330 V
potential.
There is a danger of electric shock by this high voltage when the
capacitor is handled by hand. The electric shock is caused by the
charged voltage which is kept without discharging when the main
power of the unit is simply turned off. Therefore, the remaining
voltage must be discharged as described below.
Preparing the Short Jig
To preparing the short jig, a small clip is attached to each end of
a resistor of 1 kΩ /1 W (1-215-869-11).
Wrap insulating tape fully around the leads of the resistor to
prevent electrical shock.
Wrap insulating tape.

SUBSIDIARY MATERIALS

G: Grease
G-15 (J-6082-619-A)
G-85 (J-6082-626-A)
G-116 (J-6082-628-A)
SLT-A33/A33L/A33Y/A55/A55V/A55L/A55VL/A55VY_L2
– ENGLISH –
Cut and remove the part of gilt
which comes off at the point.
(Be careful that some
pieces of gilt may be left inside)
Note: Note: High-voltage cautions High-voltage cautions
Discharging the Capacitor
Short-circuit between the two points with the Short-circuit between the two points with the
short jig about 10 seconds. short jig about 10 seconds.
To avoid the spark with the metal plate, To avoid the spark with the metal plate,
wrap the short jig with the insulation tape. wrap the short jig with the insulation tape.
ST-233 Complete Board
R:1 kΩ/1 W
(Part code: 1-215-869-11)
2-2
G
– JAPANESE –
Note:
ST-233
R:1 kΩ/1 W
( : 1-215-869-11)