Note For Repair - Sony E 4/10-18 OSS Service Manual

NOTE FOR REPAIR

• Make sure that the flat cable and flexible board are not cracked of bent at the terminal.
Do not insert the cable insufficiently nor crookedly.
• When remove a connector, don ʼ t pull at wire of connector. It is possible that a wire is snapped.
• When installing a connector, don ʼ t press down at wire of connector.
It is possible that a wire is snapped.
• Do not apply excessive load to the gilded flexible board.
UNIVERSAL WRENCH
In case of the following notches or holes are located in the lens block, etc. during disassembling/
assembling the lens, Use the universal wrench.
Notches Holes
How to Use
Universal wrench
J-6082-609-A
Attach the chip-A or chip-B to the universal wrench.
For the notches: chip-A
For the holes: chip-B
Match the universal wrench to the holes or notches of the lens block, etc.
Match the universal wrench
Universal wrench
to the width of holes or notches.
Chip
Chip
SERVICE TOOLS
B-110 Bond (B-110) J-6082-617-A
LOCTITE 460 or
LOCTITE 460 or
the equivalent
the equivalent
SEL1018 (E 4/10-18 OSS) (E 10-18mm F4 OSS)
Cut and remove the part of gilt
which comes off at the point.
(Be careful or some
pieces of gilt may be left inside)
Chip-A for Chip-B for
universal wrench: universal wrench:
J-6082-609-1 J-6082-609-2
Chip-A
Chip-A
Notches
Chip-B
Chip-B
Holes
2. DISASSEMBLY
2-1