IBM SC34-5764-01 Manual page 245

For both large and small numbers some form of exponential notation is useful, both to make long numbers
more readable, and to make execution possible in extreme cases. In addition, exponential notation is used
whenever the "simple" form would give misleading information.
For example:
numeric digits 5
say 54321*54321
would display 2950800000 in long form. This is clearly misleading, and so the result is expressed as
2.9508E+9 instead.
The definition of numbers is, therefore, extended as:
blanks sign
The integer following the E represents a power of ten that is to be applied to the number. The E can be in
uppercase or lowercase.
Certain character strings are numbers even though they do not appear to be numeric to the user.
Specifically, because of the format of numbers in exponential notation, strings, such as 0E123 (0 raised to
the 123 power) and 1E342 (1 raised to the 342 power), are numeric. In addition, a comparison such as
0E123=0E567 gives a true result of 1 (0 is equal to 0). To prevent problems when comparing nonnumeric
strings, use the strict comparison operators.
Here are some examples:
12E7 = 120000000
12E-5 = 0.00012
-12e4 = -120000
0e123 = 0e456
0e123 == 0e456
The preceding numbers are valid for input data at all times. The results of calculations are returned in
either conventional or exponential form, depending on the setting of NUMERIC DIGITS. If the number of
places needed before the decimal point exceeds DIGITS, or the number of places after the point exceeds
twice DIGITS, exponential form is used. The exponential form REXX generates always has a sign
following the E to improve readability. If the exponent is 0, then the exponential part is omitted—that is, an
exponential part of E+0 is never generated.
You can explicitly convert numbers to exponential form, or force them to be displayed in long form, by
using the FORMAT built-in function (see page 185).
Scientific notation is a form of exponential notation that adjusts the power of ten so a single nonzero digit
appears to the left of the decimal point. Engineering notationis a form of exponential notation in which
from one to three digits (but not simply 0) appear before the decimal point, and the power of ten is always
expressed as a multiple of three. The integer part may, therefore, range from 1 through 999. You can
control whether Scientific or Engineering notation is used with the instruction:
SCIENTIFIC
NUMERIC FORM
ENGINEERING
VALUE
Scientific notation is the default.
digits
digits.digits
blanks .digits
digits.
/* Displays "1" */
/* Displays "1" */
/* Displays "1" */
/* Displays "1" */
/* Displays "0" */
;
expression
Numbers and Arithmetic
E digits
sign
Chapter 16. Numbers and Arithmetic
blanks
223