Maintenance - Wel-Bilt 1433781 Owner's Manual

4. Hold the brush cap with the carbon brush and slightly insert into the brush tube. Make
sure curvature of brush matches curvature of motor and that brush moves freely in
brush tube.
5. Replace brush cap and tighten securely. Do not overtighten.

MAINTENANCE

WARNING: Make sure this tool is disconnected from its power source before attempting
any maintenance, cleaning, or inspection.
• Maintain your tools. It is recommended that the general condition of any tool be exam-
ined before it is used. Keep your tools in good repair by adopting a program of conscien-
tious repair and maintenance in accordance with the recommended procedures found in
this manual. If any abnormal vibrations or noise occurs, turn the tool off immediately and
have the problem corrected before further use. Have necessary repairs made by qualified
service personnel.
• Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting
edges are less likely to bind and are easier to control. Keep handles dry, clean, and free
from oil and grease.
• Cleaning. Use only soap and a damp cloth to clean your tools. Many household cleaners
are harmful to plastics and other insulation. Never let liquid get inside a tool.
1. When not in use the grinder should be stored in a dry, frostfree location not within the
reach of children.
2. Keep ventilation slots of the grinder clean at all times and prevent any foreign matter
from entering.
3. If the enclosure of the grinder requires cleaning do not use solvents but a moist soft cloth
4. Regularly check the carbon brushes. Brushes should be replaced before they wear out.
Both brushes should be replaced at the same time.
7