Table of Contents
Advertisement
Start Engine
!
Notice
If your engine is starting, do an inspection on
the top cooling fan, and ensure it is operating.
Otherwise, you should stop the engine.
!
Notice
If the engine starts but does not run, make certain that the generator is on a flat, level surface. The
engine is equipped with a low oil sensor that will prevent the engine from running when the oil level
falls below a critical threshold.
!
Caution
1.
This generator must have at least 5 feet (about 1.5 meters) of clearance from combustible material.
2.
Leave at least 3 feet (about 1 meter) of clearance on all side of the generator to allow for adequate
cooling, maintenance and servicing.
3.
Place the generator in a well-ventilated area.
4.
DO NOT place the generator near vents or intakes.
Step 1: Open gas fuel source (NG or LPG).
Step 2: Turn engine switch at ON position.
Step 3: Push electric start push button to
start engine. If the engine fails to start
with 5 seconds, release the button and
wait at least 5 seconds before attempting
to start engine again.
Step 4: Turn circuit breaker at ON position.
16
Advertisement
Table of Contents
