Table of Contents
Advertisement
Pre-operation Check
NG
(1) LPG / NG Change-Over-Switch
(2) Check if engine oil is enough.
(3) Check gas supply source is in good condition.
Check gas inlet connection is tightly fixed, not leaking.
(4) AC circuit breaker is at OFF position.
(5) AC output no load connected.
Disconnect all electrical loads from the generator set
before starting engine. The generator may be hard to
start if a load is connected.
(6) DC output is nothing connected.
(7) Ground terminal is properly grounded.
LPG
15
Advertisement
Table of Contents
