Environment; Regulatory Compliance; Fcc Compliance And Advisory - Kodak ESP 3 User Manual

Chapter 9

Environment

Caution Excessive dust levels may damage internal parts.
Caution Unplug the equipment from the wall outlet before cleaning.
Caution Dropping your printer may damage the housing and result in extensive
damage that will require repair by a qualified technician to restore normal operation.
Warning
KODAK AC adaptors are intended for indoor use only. The use of controls,
adjustments or procedures other than those specified herein may result in exposure
to shock and/or electrical or mechanical hazards.
Caution Adjust only those controls covered in the operating instructions.
For more information, go to www.Kodak.com/go/MSDS.

Regulatory compliance

FCC compliance and advisory

This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed or used
in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, you are encouraged to try to correct the
interference by one or more of the following measures: 1) reorient or relocate the receiving
antenna; 2) increase the distance between the equipment and the receiver; 3) connect the
equipment to an outlet on a circuit other than that to which the receiver is connected; 4) consult
the dealer or an experienced radio/TV technician for additional suggestions.
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment. Where shielded interface cables have
been provided with the product or specified additional components or accessories elsewhere
defined to be used with the installation of the product, they must be used in order to ensure
compliance with FCC regulation.
Caution When using the Bluetooth interface with a Kodak printer, the transmitter
must not be collocated or operate in conjunction with any other antenna or
transmitter.
60
Do not expose this product to liquid, moisture or extreme temperatures.
Kodak ESP·3 All-in-One