Use - Drying - Electrolux EWW14791W User Manual

8 use – drying electrolux washer-dryer
Use – drying
Drying only
caution
The water tap must be open and the drain hose must
be positioned in the sink or connected to the drain
pipe.
1. Load the laundry.
2. Select a spin cycle at the maximum spin speed allowed
for the type of laundry in order to obtain the best drying
performances.
3. Select the drying program for Cottons or Synthetics in
the Drying sector of the program selector dial.
4. If you wish to select a drying program, depress the
Drying level button until the icon corresponding to
the required dryness degree appears on the display,
marked with the icon
5. If you wish to select timed drying, press the Drying time
button until the time you want appears on the display
(see the "Drying Program" table). Every time you press
this button the drying time increases by 5 minutes.
NOTE: The program time will automatically increase by
some minutes.
6. Press the Start/Pause button to start the program. After
the program has started, the time remaining is updated
every minute.
NOTE: The different type of cottons (towelling, sheets,
shirts, and so on) or any laundry items rolling up during
the spinning phase may result in partial dryness. In the
exceptional case that at the end of the cycle the laundry
remains slightly wet, we suggest that you unfold the
rolled up items, redistribute them evenly in the drum
and select an additional drying cycle of 20-30 minutes.
7. At the end of the program, the buzzer sounds and three
blinking appear on the display and the door is locked.
The last 10 minutes of the drying cycle correspond
to an anti-crease phase. During this time the door is
locked and the display keeps showing three flashing
zeros .
tips and information
If you wish to open the door before or during the anti-
crease phase or to interrupt it, press any button or turn the
program selector dial to any program position (except
.
8. Turn the selector dial to the
machine off.
9. Remove the laundry.
Automatic washing and drying (NON-STOP program)
For NON-STOP programs, the recommended load size is
4kg for cottons and 3kg for synthetics.
caution
Do not use a dosing device/ball when carrying out a
washing and drying program.
1. Load the laundry.
2. Add detergent and fabric softener.
3. Switch the machine on by turning the selector dial to
the selected washing program/fabric.
4. Select the required options by pressing the relevant
buttons.
If possible, do not select a spin speed lower than that
proposed by the appliance to avoid too long a drying
time therefore saving energy.
In any case the reduction of the spin speed is only
possible after selecting drying.
The lowest values you can select are the following:
– 900 rpm for cottons and synthetic with electronic
drying;
– 900 rpm for cottons and 700 rpm. for fabrics with
timed drying.
5. Select the drying time by pressing the Drying time
button or dryness degree by pressing the Drying level
button. The display shows the entire duration of the
washing and the selected drying cycle.
6. Start the program by pressing the Start/Pause button.
After the program has started, the time remaining is
updated every minute.
7. At the end of the program turn the selector dial to the
position to switch the machine off.
8. Remove the laundry.
).
position to switch the